User manual HANDY TERMINAL
30
Charging
The internal backup battery charges off the main battery pack and requires 2 hours charge time to
backup RAM data for 24 hours. You can begin using the Handy Terminal after charging the main
battery for four or six hours (depending upon your battery); however, the internal backup battery
will continue to charge off the main battery.
To ensure that the internal backup battery functions properly, maintain a consistent power supply
for the first eight hours of terminal operation. This power supply can be external power (using a
charging peripheral) or an installed, charged battery pack or a combination of both.
4.22.
Resetting the Terminal
Soft Reset:
Using the stylus press and release the
Reset
button. This resets RAM and reloads the OS.
Hard Reset:
Using the stylus press and hold the
Reset
button and then press and release the
Power
button. This resets RAM, reloads the OS, and resets the Real Time Clock.
Soft Reset (Warm Boot)
A soft reset re-boots the terminal without losing RAM data, terminates all running applications,
reloads the OS, and launches Autoinstall, which re-initializes any CAB or REG files in
\
AutoInstall
\
Cabfile
folder.
You would perform a soft reset 1) when the terminal fails to respond, 2) after installing software
applications that require a reboot, or 3) after making changes to certain system settings, or 4) to
install new CAB or REG files.
1. Press the
Reset
button. The screen turns white and the decode and scan LED flashes blue for
approximately 10 seconds.
2. When the reset is complete, the Desktop appears.
Hard Reset (Cold Boot)
CAUTION:
A hard reset erases all of the data and applications stored in RAM memory, reloads the
OS, resets the Real Time Clock(RTC) and launches Autoinstall, which installs any CAB or REG files in
the
\
AutoInstall
\
Cabfile
.
Hard resets automatically launch a soft reset as part of the boot process if there are CAB files
present.
1. Press and hold the
Reset
button and then press and release the
Power
button. The screen turns
white and the decode and scan LED flashes red for approximately 20 seconds.
2. The terminal re-initializes, which re-installs all programs stored in the
\
Autoinstall
\
Cabfile
folder.
☞
☞
☞
☞
NOTE:
Set the time and date after each hard reset to ensure that the system clock is accurate.
Double-click the date
on the command bar to open the Clock setting and set the time and date.
4.23.
Suspend Mode
Suspend Mode suspends terminal operation. The terminal appears to be “off” when in Suspend
Mode. The terminal is programmed to go into Suspend Mode automatically when inactive for a
specified period of time. You can set this time period in the Power setting.
To suspend and resume operation, press the
Power
button. You may also press the front Scan key
to wake a suspended device unless the battery door has been removed and replaced.
Summary of Contents for HT-K10-SC
Page 1: ......
Page 66: ...User manual HANDY TERMINAL 65...