Instruction manual
S14-250 ver. 2020
8/15
3.2. Installing the take-off board set in the foundation tray
To install the take-off base board (item 2) with white take-off board (item 3) in the embedded tray (item 1) use the
included flat wrench no. 24 (item 8). The installation begins with placing the synthetic base board (item 2), with white
take-off board (item 3) fastened on its top, in the embedded tray (item 1), so that the square heads of the blocking
synthetic bolts (see b, drawing 3, page 11) point the landing area. The length of the adjusting feet (see g, drawing 3) of
the base board (item 2) is set during the production process to ensure that the edges of the white take-off board (item
3) are on the same level as the short edges of the foundation tray are.
If the white take-off board edges (item 3) are on the same level as the runway surface, you can secure the synthetic
base board (item 2) with white take-off board (item 3) inside the tray (item 1) by unscrewing the blocking synthetic
bolts counterclockwise until perceptible resistance occurs, with the included wrench 24 (item 8).
If the white take-off board edges (item 3) are not levelled with the runway surface, the length of the adjusting feet (see
g, drawing 3) of the base board (item 2) need to be re-regulated, so please do the following:
- take out the whole set from the tray,
- unscrew the white take-off board (item 3)
from the base board (item 2) using the
included screwdriver (item 11),
