5
AU
Telephone Helpline: 1300225960
Should the parameter need adjusting:
1. Press and hold the
SET
button for six seconds. The “E1” parameter is displayed
2. Press the
or
buttons until the required value is displayed
3. Press the
SET
button to store the new value and cycle to the next parameter
NOTE: The controller times out after 10 seconds if no buttons are pressed
Manual Defrost:
Press and hold the button for 6 seconds to begin automatic defrost. The defrost light illuminates
Cleaning, Care & Maintenance
1.
Switch off and disconnect from the power supply before cleaning.
2. The doors can be removed for ease of cleaning
3. Clean the interior of the appliance as often as possible
4. Do not use abrasive cleaning agents. These can leave harmful residues
5. Clean the door seal with warm soapy water
6. Always wipe dry after cleaning
Replacing the Interior Lamp
Call your POLAR dealer or a qualified electrician, the Lamp Assembly is available to purchase as a spare
part.
Cleaning the Condenser
Periodically cleaning the condenser can extend the life of the appliance. POLAR recommend that a POLAR
agent or qualified technician clean the condenser.
Troubleshooting
If your POLAR appliance develops a fault, please check the following table before making a call to the
Helpline or your POLAR dealer.
Fault
Probable Cause
Solution
The appliance is not
working
The unit is not switched on
Check the unit is plugged in correctly and
switched on
Plug and lead are damaged
Call POLAR agent or qualified Technician
Fuse in the plug has blown
Replace the fuse
Power supply
Check power supply
Internal wiring fault
Call POLAR agent or qualified Technician
CD229-A_CD230-A_A5_v2_20200903.indb 5
CD229-A_CD230-A_A5_v2_20200903.indb 5
2020/9/3 09:40
2020/9/3 09:40
