2
Telephone Helpline
:
1300225960
Pack Contents
The following is included:
POLAR prides itself on quality and service, ensuring that at the time of packaging the contents are supplied
fully functional and free of damage.
Should you find any damage as a result of transit, please contact your POLAR dealer immediately.
Installation
1.
Remove the appliance from the packaging. Make sure that all protective plastic film and coatings are
thoroughly removed from all surfaces.
2.
Maintain a distance of 20cm (7 inches) between the unit and walls or other objects for ventilation.
Increase this distance if the obstacle is a heat source.
Fitting the Shelves
1.
Place the shelf guides on either side of the cabinet at the desired height.
2.
Lower the shelf into place, slotting the rear of the shelf into the corresponding holes. Ensure the
shelves are level.
3.
Repeat for the remaining shelves.
Operation
Turn On (
1.
Close the door of the appliance.
2.
Connect the appliance to a mains power supply.
3.
Press the
button to turn the light On and Off as required
Setting the Operating Temperature
1.
Press the
button. The display will flash.
2.
Press the
or
buttons to display the required temperature
3.
Press the
button to store the temperature
Note: If the appliance has been stored or moved in a non-vertical position, stand it in an
upright position for approximately 12 hours before operation. If in doubt allow to stand.
Note: Before using the appliance for the first time, clean the shelves and interior with
soapy water.
•
POLAR Display Chiller
•
Instruction manual
•
Shelves
4
