EVCO S.p.A.
Vcolor 869
| Installer manual ver. 1.0 | Code 144VC869E104
page 24 of 92
6
OPERATION
6.1
Initial information on operating cycles
The device is capable of operating in the following modes:
-
temperature controlled blast chilling and conservation
-
hard temperature controlled blast chilling and conservation
-
time controlled blast chilling and conservation
-
hard time controlled blast chilling and conservation
-
temperature controlled blast-freezing and conservation
-
soft temperature controlled blast-freezing and conservation
-
time controlled blast-freezing and conservation
-
soft time controlled blast-freezing and conservation
-
multineedle probe continuous cycle
-
multi-timer continuous cycle
-
pre-cooling
-
fish sanitation
-
thawing
-
defrosting
-
ice cream hardening
-
sterilisation
-
heating the needle probe
-
drying
Upon use of the optional expansion module, the following functions are also available:
-
proofing
-
slow cooking
For more information see the subsequent sections.
6.2
Initial information on the needle probe
This device is capable of managing multipoint needle probes (with up to three sensors) or multineedle probes (up to
three probes).
To set the type of probe to be used, configure parameter P3:
P3=0
no needle probe;
P3=1
a single needle probe;
P3=2
multineedle probe (multiple independent needle probes);
P3=3
multipoint needle probe (multiple sensors in the same probe).
Once the type of probe has been set, parameter P9 sets:
the number of probes, when P3=2 (multiprobe);
the number of sensors, when P3=3 (multipoint).
If a multipoint probe is to be used for running temperature controlled blast chilling, blast-freezing and sanitation cycles,
the hottest sensor will be used as the reference point. For slow cooking cycles and for heating the probe, the coldest
sensor will be used.
