EVCO S.p.A.
Vcolor 869
| Installer manual ver. 1.0 | Code 144VC869E104
page 33 of 92
7.5
Setting the set points
7.5.1
Setting the cabinet temperature set point
When selecting a continuous or customized blast chilling or blast-freezing cycle, the pre-set cabinet temperature,
product temperature, time and fan speed values when the parameters were set are loaded. These can be modified by
the user within the permitted range for the parameters. To make a modification press the
key next to the value to
be edited. The screen shown below will appear and the editable value will become orange.
Set the desired value using the
key. Once set-up is complete press the
next to the edited value
and return to the previous screen.
7.5.2
Setting the product temperature set point
Proceed as described for the cabinet set point, after pressing area
for the product temperature (or the
temperature indicated by the needle probe).
7.5.3
Setting the cycle duration
Proceed as described for the cabinet set point, after pressing area
for the cycle duration.
7.5.4
Setting the fan speed
Proceed as described for the cabinet set point, after pressing area
for the fan speed.
The minimum fan speed value that can be set for all cycles (except for slow cooking) is given by parameter F53.
The minimum fan speed value that can be set for slow cooking is given by parameter F54.
