EVCO S.p.A.
Vcolor 869
| Installer manual ver. 1.0 | Code 144VC869E104
page 37 of 92
8
SPECIAL CYCLES
Press this area on the Home page to open the screen shown below.
This screen grants access to further functions, some always present, others that can be activated by setting the
parameter. If the function is not available, the area relating to that function and enabling it to be selected will not be
shown.
The functions available are listed below
Pressing this area enables selection of a fish sanitation cycle (a function always shown); see section
Errore. L'origine riferimento non è stata trovata.
.
Pressing this area enables selection of a thawing cycle (a function always shown); see section
Errore.
L'origine riferimento non è stata trovata.
.
Pressing this area enables selection of a manual defrost cycle (a function always shown); see section 8.3.
Pressing this area enables selection of an ice cream hardening cycle (a function always shown); see
section 8.4.
Pressing this area enables selection of a sterilisation cycle (a function activated by parameter); see
section
Errore. L'origine riferimento non è stata trovata.
.
Pressing this area enables selection of a needle probe heating cycle (a function activated by parameter if
at least one needle probe is being used); see section 8.6.
