EVCO S.p.A.
Vcolor 869
| Installer manual ver. 1.0 | Code 144VC869E104
page 57 of 92
10
PRE-COOLING
Pressing this area on the Home page enables selection of a pre-cooling cycle. This cycle is similar to a normal blast
chilling cycle and it may precede all operating cycles.
Pressing the area in question opens the following screen.
Set the required set point value and press area
to start the cabinet pre-cooling cycle. The screen below will
be displayed showing the pre-cooling cycle in process.
The fan speed is fixed and set by parameter F28.
Press the
key to stop pre-cooling.
Once the required cabinet set point has been reached, the buzzer sounds and the cycle continues maintaining the
cabinet temperature achieved until the
key is pressed. The controller will automatically return to the
Home page.
