EVCO S.p.A.
Vcolor 869
| Installer manual ver. 1.0 | Code 144VC869E104
page 64 of 92
13
USING THE USB PORT
13.1
Initial information
The USB port makes possible the following operations.
upload and download settings of “MY COOKBOOK” recipes and of “Special cycles” working cycles (hereinafter
referred to as “programs”);
upload and download configuration parameter settings;
download historical HACCP information.
These operations are guaranteed by using an EVCO EVUSB4096M USB device.
Uploading operations are only possible if the firmware of the device from which it originates and the firmware of the
destination device(s) are the same. This information is available in the SERVICE page.
13.1.1
Uploading program settings (USB
controller)
To upload the settings of the programs, operate as follows:
1.
Make sure the device is in stand-by and no procedure is underway;
2.
Insert the USB flash drive into the USB port and wait until the menu is displayed;
3.
Touch “UPLOAD PROGRAMS”;
4.
When the upload is complete, remove the USB flash drive from the device USB port.
13.1.2
Downloading program settings (controller -> USB)
To download the settings of the programs, operate as follows:
1.
Make sure the device is in stand-by and no procedure is underway;
2.
Insert the USB flash drive into the USB port and wait until the menu is displayed;
3.
Touch “DOWNLOAD PROGRAMS”;
4.
When the upload is complete, remove the USB flash drive from the device USB port.
13.1.3
Uploading configuration parameter settings (USB
controller)
To upload the settings of the configuration parameter, operate as follows:
1.
Make sure the device is in stand-by and no procedure is underway;
2.
Insert the USB flash drive into the USB port and wait until the menu is displayed;
3.
Touch “UPLOAD PARAMETERS”;
4.
When the upload is complete, remove the USB flash drive from the device USB port.
