7. FUEL INJECTOR SYSTEM
7-4
High Pressure Fuel Line Disassembly
Loosen the special fuel line clamp on fuel injector cap.
loosen the special fuel line clamp on fuel tank.
Disassemble High pressure fuel line.
High Pressure Fuel Line Installation
Reverse the disassembly procedure for installation.
Use clamp calliper to install the special fuel
line clamp.
Throttle Body Disassembly
Remove the connector of throttle valve opening sensor.
Remove the connector of idling solenoid valve sensor.
Loosen locknut, remove adjust nut and remove the
throttle cable from throttle rotory sleeve.
Loosen air filter clamp.
Remove intake tube of air filter.
Remove 4 bolts and remove throttle body.
Throttle Body Installation
Reverse the disassembly procedure for installation.
NOTE: Use container to keep the remaining fuel
from high pressure fuel line, when loosening
the special fuel line clamp
.
NOTE:
Do not adjust the bolt on throttle body.
Do not remove the cap on throttle body.
Summary of Contents for 1100 GKE OutLaw
