11. EFI SYSTEM OF SQR 472ENGINE
11-58
2.36. Two cylinder ignition coil circuit fault (fault code P0352)
Serial
number
Operation steps
Test
results
Next step
1
round which is diagnostic instrument, the
ignition switch is in the "ON"
Next
step
Yes
To step 4
2
Dial the joint on wire harness for ignition
coil, using a multimeter to check voltage
between the 2# pin and the negative pole of
the power supply is 12V.
No Next
step
Yes
Repair or replace the wire harness
3
Check the ignition coil between the 2# pin
and the 87# pin of main relay circuit is open
circuit or short circuit to ground;
No
To step 5
Yes
Repair or replace the wire harness
4
Between the A31# pin check phase sensor
and papillary 1# pins and ECU line is open
circuit or short circuit to ground.
No Next
step
Yes Next
step
5
Using a multimeter to check the ignition
coil resistance 1# pin and 2# pin between,
stop should be 0.67 +/-10%
No
Replace ignition coil
Yes Diagnostic
aid
6
By using the universal resistance between
the table to check the ignition coil 2
cylinder column and ignition anode, stop
should be 9.2K
Ω
+/-20%
No
Replace ignition coil
2.37. Three cylinder ignition coil circuit fault (fault code P0353)
Serial
number
Operation steps
Test
results
Next step
1
round which is diagnostic instrument, the
ignition switch is in the "ON"
Next
step
Yes
To step 4
2
Dial the joint on wire harness for ignition
coil, using a multimeter to check voltage
between the 2# pin and the negative pole of
the power supply is 12V.
No Next
step
Yes
Repair or replace the wire harness
3
Check the ignition coil between the 2# pin
and the 87# pin of main relay circuit is open
circuit or short circuit to ground;
No
To step 5
Yes
Repair or replace the wire harness
4
Between the A31# pin check phase sensor
and papillary 1# pins and ECU line is open
circuit or short circuit to ground.
No Next
step
Yes Next
step
5
Using a multimeter to check the ignition
coil resistance 1# pin and 2# pin between,
stop should be 0.67 +/-10%
No
Replace ignition coil
Yes Diagnostic
aid
6
By using the universal resistance between
the table to check the ignition coil 3
cylinder column and ignition anode, stop
should be 9.2K
Ω
+/-20%
No
Replace ignition coil
Summary of Contents for 1100 GKE OutLaw
