11. EFI SYSTEM OF SQR 472ENGINE
11-62
2.44. Internal control (read-only memory) fault (fault code P0605)
Serial
number
Operation steps
Test
results
Next step
1
Connect the diagnostic instrument, wait
for 30 seconds or more, to the ignition
switch is in the "ON"
Next
step
Yes
To step 3
2
Check whether the fault code
No
Yes
The replacement of ECU
3
Switch off ignition, disconnect the
battery positive power supply, waiting
for more than 30 seconds, to the ignition
switch is in the "ON". Check whether
there is a fault code
No
2.45. Fault display lamp control circuit fault (fault code P0650)
Serial
number
Operation steps
Test
results
Next step
1
Connect the diagnosis instrument, the
ignition switch is in the "ON"
What's
nex
To step 4
2
Pulling off the fault lamp connector, pin
voltage check 1# and dia warm cathode
will is about 12V
Next
step
Repair or replace the wire harness
3
Check the main relay power supply
circuit, short circuit, open circuit fault
exists.
To step 5
Repair or replace the wire harness
4
Check the 2# pin and ECU pin X! _70
association exists between the open circuit
fault.
What's
nex
Diagnostic
aid
5
Check the fault lamp if there is a problem
Replace faulty lamp
Summary of Contents for 1100 GKE OutLaw
