4. COOLING SYSTEM
4-4
Pressure testing of cooling system
Install the radiator cap tester to the radiator cap;
Apply the specified pressure (radiator cap opening
pressure) for 6 seconds and make sure that there is drop in
pressure.
Note
Do not apply pressure over the specified pressure
[108~137kpa(1.1~1.4kgf/cm
2
)], or the cooling system
may be
damaged.
In case there is any pressure leakage, check the pipe, joint
parts, joints of water pump and drainage (
→
4-5).
Replacing Coolant, Air Discharge
Preparation of coolant
Coolant is toxic, DO NOT drink or splash it to skin,
eyes, and clothes.
—
If
coolant splashes in your eyes, thoroughly wash
your eyes with water and consult a doctor.
—
If coolant splashes on your clothes, quickly wash it
away with water and then with soap and water.
—
If coolant is swallowed, induce vomit immediately
and see a physician.
—
Store the coolant properly and keep it away from
reach of children.
Note
Mix the coolant (undiluted) with soft water according
to the temperature 5
℃
lower than the actual lowest
local temperature.
Coolant should be made from undiluted coolant with soft
water.
Standard density of coolant: 30%
Recommended coolant: XYPOWER coolant
(Direct application without having to be diluted)
Drainage of coolant
Remove radiator cap cover
Note
Open the radiator cap after the coolant is fully cooled.
Remove:
Remove Radiator cap. (
→
4-3)
Summary of Contents for 1100 GKE OutLaw
