3
Cleaning, Care & Maintenance
•
Defrost appliance at least every 3 months, more often if required
•
Switch off and disconnect from the power supply before cleaning.
•
Clean the interior of the appliance as often as possible.
•
Do not use abrasive cleaning agents. These can leave harmful residues.
•
Clean the door seal with water only.
•
Always wipe dry after cleaning.
•
Do not allow water used in cleaning to run through the drain hole into the evaporation pan.
•
Take care when cleaning the rear of the appliance. Sharp edges can cut.
•
A POLAR agent or qualified technician must carry out repairs if required.
Stainless Steel Care.
To maintain the stainless steel exterior of your Polar item, please consider the following information:
Never:
•
Use abrasive Scourers or scrubbing pads etc
•
Use Chlorinated or acidic detergents
•
Allow anything e.g. food, dirt, cleaning chemicals to remain on the surface for longer than necessary, clean them off right away.
•
Allow the surface to remain wet.
Do:
•
Clean often.
•
Use soft Cloths or plastic Scourers.
•
Rub with the grain of the metal, rather than across it.
•
Use detergents and polish designed for cleaning Stainless Steel.
•
Ensure that the cleaning products are washed off fully and that the steel is left dry.
Cleaning the Condenser
The condenser is part of the refrigeration system. The condenser requires monthly cleaning.
Always disconnect power supply before carrying out Routine Maintenance.
Failure to clean the condenser will reduce the performance and life of your Polar unit and may invalidate
your warranty
The condenser is located above the refrigeration cabinet. These models have a removable filter which
can be cleaned with a vacuum cleaner.
Summary of Contents for DL893-A
Page 8: ...DL893 A_DL899 A_A4_v6 ...
