background image

1

UK

Safety Tips

Position on a flat, stable surface.

A service agent/qualified technician should carry out installation and any 
repairs if required. Do not remove any components or service panels on 
this product.

Consult Local and National Standards to comply with the following:

• Health and Safety at Work Legislation
• BS EN Codes of Practice
• Fire Precautions 
• IEE Wiring Regulations
• Building Regulations

DO NOT use jet/pressure washers to clean the appliance.

DO NOT use the appliance outside.

DO NOT use this appliance to store medical supplies.

DO NOT use electrical appliances inside the appliance (e.g. heaters, ice-
cream makers etc.)

DO NOT stand or support yourself on the base, drawers or doors.

DO NOT allow oil or fat to come into contact with the plastic 
components or door seal. Clean immediately if contact occurs.

Bottles that contain a high percentage of alcohol must be sealed and 
placed vertically in the refrigerator.

Always carry, store and handle the appliance in a vertical position and 
move by holding the base of the appliance.

Always switch off and disconnect the power supply to the unit before 
cleaning.

Keep all packaging away from children. Dispose of the packaging in 
accordance with the regulations of local authorities.

If the power cord is damaged, it must be replaced by a POLAR agent or 
a recommended qualified technician in order to avoid a hazard.

Product Description

G590

 - 400 litre Single Door Stainless Steel Refrigerator

G591

 - 400 litre Single Door Stainless Steel Freezer

G592

 - 600 litre Single Door Stainless Steel Refrigerator

G593

 - 600 litre Single Door Stainless Steel Freezer

G594

 - 1200 litre Double Door Stainless Steel Refrigerator

G595

 - 1200 litre Double Door Stainless Steel Freezer

U629

 - 600 litre Single Glass Door Refrigerator

U630

 - 1200 litre Double Glass Door Refrigerator

Introduction

Please take a few moments to carefully read through this manual. Correct 
maintenance and operation of this machine will provide the best possible 
performance from your POLAR product.

Pack Contents

The following is included:

POLAR prides itself on quality and service, ensuring that at the time of 
packaging the contents are supplied fully functional and free of damage.
Should you find any damage as a result of transit, please contact your POLAR 
dealer immediately.

Installation

1. Remove the appliance from the packaging. Make sure that all protective 

plastic film and coatings are thoroughly removed from all surfaces. 

2. Maintain a distance of 20cm (7 inches) between the unit and walls or 

other objects for ventilation. Increase this distance if the obstacle is a 
heat source. 

3. Level the appliance by adjusting the screw feet.

Removing the Compressor Safety Band 

(G592/G593/G594/G595/U629/U630 only)

The compressor is located on the top of the appliance, and sits on rubber 
washers. Under normal operating conditions the compressor is allowed to 
vibrate. 
To avoid damage through excessive motion during transit, a stainless steel 
safety band is placed over the compressor and screwed into the top of the 
appliance.
This safety band and the two screws fixing it to the appliance 

must be 

removed

 before the appliance is turned on.

Fitting the Waste Water Tray 

(G592/G593/G594/G595/U629/U630 only)

The waste water tray and supports comes ready to fit to the underside of the 
appliance.
1. Carefully tip the appliance to gain access to the underside.
2. Screw the supports into the holes on the underside of the appliance, 

using the screws and washers provided.

3. Lower the appliance and slide the tray onto the supports.

Note: If the unit has been stored in a non-vertical position, 
stand it in an upright position for approximately 12 hours 
before operation. 

Note: Before using the appliance for the first time, clean the 
internal cabinet and shelves with soapy water.

Compressor 

Safety Band

Screws

Compressor

POLAR Refrigerator or Freezer

Keys  x  2

Shelf guides x 8 (Single)/ 
x 16 (Double)

Shelves x 4 (Single)/ 
x 8 (Double)

Instruction manual

Waste water tray

Waste water tray supports x 2

Screws  x  6

Washers  x  6

Spring washers x 6

Summary of Contents for G590








Reviews: