background image

1

UK

Safety Tips

Position on a flat, stable surface.

A service agent/qualified technician should carry out installation and any 
repairs if required. Do not remove any components or service panels on 
this product.

Consult Local and National Standards to comply with the following:

• Health and Safety at Work Legislation
• BS EN Codes of Practice
• Fire Precautions 
• IEE Wiring Regulations
• Building Regulations

DO NOT use jet/pressure washers to clean the appliance.

DO NOT use the appliance outside.

DO NOT use this appliance to store medical supplies.

DO NOT use electrical appliances inside the appliance (e.g. heaters, ice-
cream makers etc.)

DO NOT stand or support yourself on the base, drawers or doors.

DO NOT allow oil or fat to come into contact with the plastic 
components or door seal. Clean immediately if contact occurs.

Bottles that contain a high percentage of alcohol must be sealed and 
placed vertically in the refrigerator.

Always carry, store and handle the appliance in a vertical position and 
move by holding the base of the appliance.

Always switch off and disconnect the power supply to the unit before 
cleaning.

Keep all packaging away from children. Dispose of the packaging in 
accordance with the regulations of local authorities.

If the power cord is damaged, it must be replaced by a POLAR agent or 
a recommended qualified technician in order to avoid a hazard.

Product Description

G604 - POLAR 2 Door Pizza/Salad Prep Counter Refrigerator
G605 - POLAR 3 Door Pizza/Salad Prep Counter Refrigerator
G606 - POLAR 2 Door Saladette Counter
G607 - POLAR 3 Door Saladette Counter

Introduction

Please take a few moments to carefully read through this manual. Correct 
maintenance and operation of this machine will provide the best possible 
performance from your POLAR product.

Pack Contents

The following is included:

POLAR prides itself on quality and service, ensuring that at the time of 
packaging the contents are supplied fully functional and free of damage.
Should you find any damage as a result of transit, please contact your POLAR 
dealer immediately.

Installation

1.

Remove the appliance from the packaging. Make sure that all protective 
plastic film and coatings are thoroughly removed from all surfaces. 

2.

Maintain a distance of 20cm (7 inches) between the unit and walls or 
other objects for ventilation. Increase this distance if the obstacle is a 
heat source. 

Fitting the Shelves & Floor Guides

1.

Place one set of shelf guides on either side of the cabinet at the desired 
height.

2.

Slide the shelf into place.

3.

Repeat for the remaining shelves.

4.

Place the floor guards on the floor of the cabinet, ensuring the flat side 
is clear of the floor.

Operation

Storing Food

To get the best results from your POLAR appliance, follow these instructions:

Only store foodstuffs in the appliance when it has reached the correct 
operating temperature.

Ensure gastronorm bays are full at all times, even if the gastronorms are 
unused or empty. Empty bays will greatly reduce efficiency of the 
appliance.

Always close the lid when not in use.

Do not place uncovered hot food or liquid inside the appliance.

Wrap or cover food where possible.

Do not obstruct the fans inside the appliance.

Avoid opening the doors for prolonged periods of time.

Turn On

1.

Close the door(s) of the appliance.

2.

Ensure the power switch is set to [O] and turn on at the socket.

3.

Switch on the Power [I]. The current temperature within the appliance 
is displayed.

Open/Close the Lid (G606/G607 Only)

The lid of the G606 and G607 Saladette Counter is multi-positional:

1.

With the lid closed, slide the panel back into the half open position.
This allows partial access to the gastronorm trays.

2.

Lift the lid up and back so the hinge settles into the support slot.

3.

Lift the lid up and completely back so the gastronorm trays are 
completely exposed.

POLAR  Refrigerator

Shelf guides

Shelves
G604/G606 x 2
G605/G607 x 3

Instruction manual

Gastronorm Adaptor Bars

Floor  Shelves
G604/G606 x 2
G605/G607 x 3

Note: If the unit has not been stored in an upright position, 
let it stand upright for approximately 12 hours before 
operation. If in doubt allow to stand.

Note: Before using the appliance for the first time, clean the 
shelves and interior with soapy water.

Note: This is vital for ensuring correct drainage of 
condensation.

WARNING: The sliding lid does not have a locking 
mechanism. Always make sure that the lid is in the ‘half-
open’ position before opening.

Summary of Contents for G604









Reviews: