Orange light (option)
The light bulb of MAXIMUM 10 W – 24 V – Use of a
light bulb of power above 10 W - 24 W can result in
improper operation of the drive unit..
▶
Assembly
Once the conductors are connected to the photocells,
proceed as follows:
•
switch on the drive power supply,
•
activate the gate opening and closing mode.
The photocells are recognized by the electronic control
system after this movement is finished.
▶
Operation using the photocells
If the photocells are covered during gate closing,
the gate will stop and start to open again.
▶
In case of photocell removal
After the photocells are removed, switch on the drive
power supply again and then carry out the procedure
„Switching off the automatic closing”, page 30.
▶
Orange light operation
The orange light flashes when the gate is moving.
34
EN
- Assembly and service manual for EASY WAY202
EN
Accessory wiring
Accessory wiring
For this drive unit, wiring of the second set of photocells is impossible.
TX
1 2
1 2 3 5
RX
B
U
S
BUS
33
44
