13
EN
1,5/2 mm
Fasten the first bar in such a way as to feel slight resistance.
[6].
Level the bar. The bars No. 1 – No. 4 have bean-shaped elements for horizontal adjustment; The toothed
bars can be adjusted vertically.
[7].
Fasten the next toothed bars to the bar No. 1. The last toothed bar on the bar No. 1 will connect the bars
No. 2 and No. 1.
[8].
Fasten the next bars and toothed bars as above.
[9].
Once the bars are fastened, check whether everything is level or not; if not, correct this.
►
Mechanical adjustment
Check if:
• the drive unit is located at a suitable height,
•
the gate moves properly: the gate should move without difficulty
along its track,
• the gear wheel is driven all the time when the gate moves along
its track,
• the set consisting of the toothed bar and the gear wheel does not
change its position substantially along the gate path.
If these conditions are not met:
[1].
Adjust the height and set the drive at a suitable level using the 4 nuts (17) located under the drive.
[2].
If necessary, adjust the position of the
toothed bar and tighten up the nuts of the
drive.
[3].
Close the gate.
[4.]
Lock the drive.
Bean-shaped
element
for horizontal
adjustment
Bean-shaped element
for vertical adjustment
Never lock the drive when the gate
is running.