34
EN
3
2
1
[1].
Put the programmed remote control with 2 or 4 push-buttons on the picture showing a target.
Press the remote control push-button 1 until the AUTOMATIC CLOSING indicator starts
flashing.
[2].
Press remote control push-button 1 once.
> MEMORY RESET indicator (RESET) is flashing.
[3].
Press remote control push-button 2 and hold it until the MEMORY RESET indicator (RESET) lights up.
Release push-button 2.
> STATUS indicator
is flashing.
►
Removal of settings
The following settings can be removed: the gate path and activation
of the automatic gate closing mode.
When are the settings to be removed?
After the gate path teaching, in the case of modification of the drive conductors.
In the case of detection of an unexpected obstacle as a consequence of normal wear of the gate.
Antenn
a
►
Antenna conductors and position
The antenna must be connected to terminal 1 of the electronic system
of the drive unit and positioned as shown in the picture on the right.