background image

WARNING

  -  to guard against injury, basic safety precautions should be 

observed, including the following:

1.  READ AND FOLLOW ALL SAFETY INSTRUCTIONS.

2.  CAUTION - Disconnect power before servicing.
3.  DANGER - To avoid possible electric shock, special care should be taken 

since water is present near electrical equipment. Unless a situation is  
encountered that is explicitly addressed by the provided maintenance 
and troubleshooting sections, do not attempt repairs yourself, refer to an 
authorized service technitian.

4.  Carefully examine the disinfection system after installation. It should not be 

plugged in if there is water on parts not intended to be wet.

5.  Do not operate the disinfection system if it has a damaged cord or plug, if it 

is malfunctioning or if it is dropped or damaged in any manner.

6.  Always disconnect water flow and unplug the disinfection system before 

performing cleaning or maintenance activities. Never yank the cord to 
remove from an outlet; grasp the wall plug and pull to disconnect.

7.  Do not use this disinfection system for other than intended use (potable 

water applications). The use of attachments not recommended or sold by 
the manufacturer/distributor may cause an unsafe condition.

8.  Intended for indoor use only. Do not install this disinfection system where 

it will be exposed to the weather or to temperatures below freezing. Do not 
store this disinfection system where it will be exposed to the weather. Do 
not store this disinfection system where it will be exposed to temperatures 
below freezing unless all water has been drained form it and the water 
supply has been disconnected.

9.  Read and observe all the important notices and warnings on the water 

disinfection system.

10.  If an extension cord is necessary, a cord with a proper rating should be used. 

A cord rated for less Amperes or Watts than the disinfection system rating 
may overheat. Care should be taken to arrange the cord so that it will not be 
ripped over or pulled.

11.  SAVE THESE INSTRUCTIONS.

WARNING:

 The UV light given off by this unit can cause serious burns to 

unprotected eyes and skin. Never look directly at an illuminated UV lamp. When 
performing any work on the UV disinfection system always unplug the unit first. 
Never operate the UV system while the UV lamp is outside of the UV chamber.

Note: 

The UV lamp inside of the disinfection system is rated at an effective life of approximately 9000 

hours. To ensure continuous protection, replace the UV lamp annually.

Polaris Scientific Ultraviolet

TM

 

warrants the ultraviolet disinfection system’s hardware 

and electrical systems to be free from defects in material and workmanship for a period 
of  five (5) years from the date of purchase by the original owner on a pro-rated basis.  

Polaris Scientific Ultraviolet

TM

 warrants the ultraviolet lamps and sensor probes to be free 

from defects in material and workmanship for a period of one (1) year and the reactor 
chamber for a period of seven (7) years. The warrantor will at its option and expense, either 
repair or replace such units subject to the following conditions, exceptions, and exclusions.

Conditions, Exceptions, And Exclusions

The foregoing limited Warranty is subject to the following terms and conditions:
1.  Water passed through the unit must fall within the following parameters:
 

a) Iron: <0.3 ppm (0.3 mg/L)

 

b) Hardness*:<7 ppm (120 mg/L)

 

c) Turbidity: < 1 NTU

 

d) Manganese: < 0.05 ppm (0.05 mg/L)

 

e) Tannins: < 0.1 ppm (0.1 mg/L)

 

f) UV Transmittance: > 75% (call factory for recommendations on                
     applications where UVT < 75%) 

 

* Where total hardness is more than 7 gpg, the water should be softened.

 

Warranty will be void, if the proper steps are not taken to ensure that these 
impurities are not present.

2.  This limited Warranty shall not apply to any unit which has been repaired or altered by 

anyone other than the Warrantor or by a person authorized by the Warrantor, nor to any 
units which have been subject to misuse, neglect, or accident. Do not remove any of the 
products labels. Warranty will be deemed null and void if any of the products original 
labels are removed.

3.  This limited Warranty runs exclusively to the original Consumer and with respect to the 

original installation only. 

4.  WARRANTOR SHALL NOT BE LIABLE FOR ANY INCIDENTAL OR  

CONSEQUENTIAL DAMAGES.

5.  This limited Warranty excludes the cost of labor in removing any defective unit or 

installing any replacement unit. This limited Warranty applies only to a unit when 
returned to the Warrantor at the owner’s expense and in accordance with shipping 
instructions received from the Warrantor.

Page 8

Page 1

WARRANTY & PATENT INFORMATION

SAFETY INSTRUCTIONS

Polaris Scientific UV and the Polaris Scientific UV logo 

design are registered Trademarks in the United States and 

certain other countries.   

The Polaris Scientific UV Germicidal Lamp Pin Design is 

patented under United States Patent Number: D751506, and 

is protected by U.S. Patent and Trademark laws.

U.S. Patent: D751506

Summary of Contents for UVA-12C













Reviews: