110
MAINTENANCE AND LUBRICATION
Battery
1. Set the battery in its holder.
2. Install the battery vent tube. It must be free from obstructions and se-
curely installed. If not, battery gases could accumulate and cause an
explosion. The tube should be routed away from the frame and body
to prevent corrosion. Avoid skin contact with electrolyte, severe burns
could result.
3. First connect and tighten the red (positive) cable.
4. Second connect and tighten the black (negative) cable.
5. Reinstall battery cover and attach the hold down strap.
6. Verify that cables are properly routed.
NOTE:
S
When your ATV is placed in storage for three months or more, the
battery should be removed, charged to proper level, and stored in a
cool dry place.
S
Before reusing, take the battery to your dealer for testing and re-
charging.
S
Power plug leads may need to be bent down so that the battery cov-
er may be installed.
S
When installing a new battery, make certain it is fully charged prior
to it’s initial use. Using a new battery that has not been fully
charged can damage the battery resulting in a shorter life of the
battery. It can also hinder vehicle performance.
Indicates a potential hazard that could result in serious injury or
death.
WARNING
Summary of Contents for 2002 Sportsman 6x6
