112
MAINTENANCE AND LUBRICATION
Lights - Adjustment - Replacement
High Beam Headlight Adjustment
The headlight beam can be adjusted to any position desired by turning
the adjusting knob located on the bottom right side of the headlight
pod.
1. Place the vehicle on a level surface with the headlight approximately
25’ (7.6 m) from a wall.
2. Measure the distance from the floor to the center of the headlight and
make a mark on the wall at the same height.
3. Start the engine and turn the headlight switch to high beam.
4. Observe headlight aim. The most intense part of the headlight beam
should be aimed 2
″
(5.1 cm) below the mark placed on the wall in step
2.
NOTE:
Rider weight must be included on the seat.
5. Adjust beam to desired position by turning the adjustment knob.
Summary of Contents for 2002 Sportsman 6x6
