73
MAINTENANCE
Spark Arrestor
Failure to heed the following warnings while servicing the spark arrestor could
result in serious injury or death. Never run the engine in an enclosed area.
Remove any combustible materials from the area. Wear eye protection and
leather work gloves. Do not stand behind or in front of the vehicle while purging.
Never go under the vehicle while it's inclined.
The exhaust system can get extremely hot. Do not perform service on the spark
arrestor while the system is hot. Allow components to cool sufficiently before
proceeding.
Use the following procedure to
periodically remove accumulated
carbon from the arrestor screen.
1. Remove the three screws and
remove the arrestor from the end of
the muffler.
2. Use a non-synthetic brush to clean
the arrestor screen. A synthetic
brush may melt if components are
warm. If necessary, blow debris
from the screen with compressed
air.
3. Inspect the screen for wear and
damage. Replace if necessary.
4. Remove and inspect the gasket.
Replace a worn or damaged gasket.
5. Reinstall the gasket and arrestor.
6. Torque screws to 50 in. lbs. (5.6 Nm).
WARNING
Screws
