TRANSMISSION
8.2
SPECIAL TOOLS
PART NUMBER
TOOL
DESCRIPTION
2871710
10” Center
Distance Tool
TORQUE SPECIFICATIONS
Item
Specification
Transmission Case
Bolts
12 ft. lbs. (16.6 Nm)
Bell Crank Nut
12 ft. lbs. (16.6 Nm)
Transmission Drain
Plug
14 ft. lbs. (19.3 Nm)
Transmission Mounting
Bolts
25 ft. lbs. (34.5 Nm)
Swing Arm Pivot Bolts
(Concentric Swingarm)
150 ft. lbs. (207.5 Nm)
LUBRICATION
Refer to maintenance section for transmission
lubricant type and capacity.
TRANSMISSION REMOVAL
1.
Remove seat, cab and air box.
2.
Remove right side heat and reservoir bracket.
3.
Remove PVT outer cover, both drive and driven
clutch, and inner PVT cover (refer to Clutch
Chapter 6).
4.
Remove rear PVT bracket.
5.
Remove carburetor.
6.
Disconnect harness from gear position switch.
7.
Remove drive chain and sprocket.
8.
Remove mounting bolts and brackets as shown.
9.
Remove
through-bolt
from
bottom
of
transmission.
10. Remove transmission from right side of frame.
TRANSMISSION
INSTALLATION
1.
Reverse removal steps to install transmission.
NOTE: Install the Center Distance Tool (PN 2871710)
on engine and transmission input shaft before
tightening transmission mounting bolts.
Align
clutches as outlined in Clutch Chapter 6.
TRANSMISSION
DISASSEMBLY
1.
Remove gear position switch.
CAUTION:
If switch is not removed prior to disassembly, switch
damage will result.
2.
Place bellcrank in neutral position.
3.
Remove sprocket retaining clip and sprocket.
4.
Remove the transmission cover bolts.
5.
With a soft face hammer tap on the (3) cover
bosses and carefully remove the cover.
Remove Switch
Tap with soft
face hammer
(3 places)
6.
Remove detent plug, washer, spring and shifting
bullet.
NOTE: Shifting bullet has a radiused end making it
directional.
PartShark.com
877-999-5686
Summary of Contents for 2009 Trail Blazer 330
