Instr 9926739
Rev 02 2018-09
Page 5 of 9
3. Install mounting plate
a
(with winch) to vehicle as
follows:
a. Upper holes: two screws
2@
installed from
FRONT to REAR. No nuts are needed.
b. Lower holes: two screws
k
installed from
REAR to FRONT, secured with nuts
1(
.
Torque screws to specification.
TORQUE
25 ft. lbs. (34 Nm) ± 10%
4. Install winch cables.
a. Loosely install 800 mm yellow cable
d
and
blue cable
f
to corresponding color posts on
winch.
b. Route opposite end of cables up through
under-hood liner towards contactor. Ensure
routing prevents contact with hot components,
sharp edges, or moving parts (including
suspension and steering components
throughout their full range of travel).
c. Loosely install yellow winch cable
d
and blue
winch cable
f
to corresponding color posts on
contactor.
d. Tighten nuts on contactor AND winch (yellow
and blue wire posts), then install terminal
boots.
e. Secure winch cables to main chassis harness
and chassis structure using cable ties
s
to
prevent contact with hot components, sharp
edges, or moving parts.
