Instr 9926739
Rev 02 2018-09
Page 7 of 9
4. Route remote socket wiring forward through
firewall accessory grommet
K
. Ensure routing
prevents contact with hot components, sharp
edges, or moving parts.
Connect wires as follows:
•
ORANGE
wire: To terminal block post with
existing ORANGE wire (accessory switched 12V
POS)
•
BLACK
wire: To mating connector from
contactor
t
.
5. Torque nut on terminal block (orange wire post) to
specification.
TORQUE
20–25 in. lbs. (2.3–2.8 Nm )
6. Secure winch socket harness using cable ties
s
to prevent contact with hot components, sharp
edges, or moving parts.
FINAL INSTALLATION
1. Carefully examine all harness routing. Ensure
harnesses are routed and secured to prevent
contact with hot components, sharp edges, or
moving parts. Use cable ties
s
as required.
2. Restore access. See beginning of procedure.
3. Reconnect black negative (-) cable to battery, then
reinstall storage compartment and seats.
4. Connect remote switch
y
to remote socket
o
.
5. Retighten all hardware after 30 minutes of riding.
