Instr 9928521
Rev 01 2017-07
Page 4 of 8
INSTALLATION INSTRUCTIONS
1. Shift vehicle transmission into “PARK”. Turn key to
“OFF” position and remove from vehicle.
2. Remove left rear passenger seat and disconnect
black negative (-) cable from battery.
3. Gain access.
a. Remove hood.
b. Remove three remaining seats.
c. Remove engine access panel (located
between rear seats).
d. Remove windshield (if installed).
e. Remove two screws
A
securing front of upper
dash panel, then carefully pull panel rearward,
disengaging seven retaining clips
B
. Retain
screws.
If necessary for access, label and disconnect
other electrical harnesses from control panel.
f.
Remove center floor console.
i.
Remove five push pin rivets
C
and four
screws
D
from front floor console. Remove
console, pushing boots for gear shift and
seat belt through console openings. Retain
rivets and screws.
ii. Remove four push pin rivets
E
and two
screws
F
from rear floor console. Remove
console, pushing boots for gear shift and
seat belt through console openings.
Disconnect RH side auxiliary power port (if
installed). Retain rivets and screws.
