DRIVE BELT INSTALLATION
1. With the L-wrench inserted into the threaded hole and the sheaves in the
open position, install the drive belt.
TIP
Install the belt so that the numbers can be read correctly on the left side of the
vehicle, or in the direction in which the belt was originally installed.
2. Wiggle the belt to remove slack while removing the L-wrench.
3. Reinstall the side panel.
4. Break in the new belt. See page 58.
TRACK
TRACK INSPECTION
WARNING
Broken track rods can cause a rotating track to come off the snowmobile,
which could cause serious injury or death. Never operate with a damaged
track. Never rotate a damaged track under power.
NOTICE
The figures below are for reference only. Your model may differ slightly.
1. Using a hoist, safely lift and support
the rear of the snowmobile off the
ground.
2. Rotate the track by hand to check for
damage.
3. Carefully examine the track along
the entire length of each rod
q
.
Bend the track to check for
breakage.
4. Replace the track if any rod damage
is found.
92
Downloaded from
Summary of Contents for 550 Indy 2022
