-2-
P/N 9924924 Rev 01 12/13
GENERAL INSTALLATION:
1. Place the vehicle in “PARK” and turn the key to
“OFF” position. Remove the key from the vehicle.
2. Slide the seat forward and remove.
3. Disconnect positive battery cable from battery with
Phillips screwdriver. Figure 1.
4. Remove front rack and center cover underneath it.
5. Remove roof, rear panel, and mirror if installed. Roof
and rear panel can be reinstalled later, but the mirror
will not fit with the audio system installed.
Battery Cables
Under Seat
Figure 1
IMPORTANT:
Your Polaris ACE AUDIO KIT is exclusively designed for your vehicle. Please read the
installation instructions thoroughly before beginning. Installation is easier if the vehicle is clean and
free of debris. For your safety, and to ensure a satisfactory installation, perform all installation steps
correctly in the sequence shown. Before you begin, thoroughly review the instructions. Ensure that
you have all the required tools and the skills necessary to complete this installation.
APPROXIMATE ASSEMBLY TIME:
30 minutes
Tools Required:
T30
Torx
Driver
Side
Cutter
10 mm Deep-Well Socket or Nut Driver
Phillips Screwdriver
Positive
Battery
Cable
6. Place one foam strip on the inside curved surface of
each of the stamped mounting brackets. Figure 2.
Figure 2
Foam Strip
Curved
Surface
