-3-
P/N 9924924 Rev 01 12/13
7. Have a second person hold the audio system in
place while the brackets are installed from the top
using the six screws removed previously. Figure 3.
NOTE:
Torque the screws to 6 ft. lbs. (8.1 Nm).
8. Route the wire harness into the hole and down
inside the right side ROPS tube then out the hole at
the bottom of the tube. Figure 4.
Figure 4
Wire
Harness
Rubber
Grommet
Figure 3
ROPS
Bracket
ELECTRICAL CONNECTIONS:
9. Remove five plastic retainers and splash shield
from inside upper right front fender. Figure 5.
Figure 5
Remove
Plastic Retainers
Splash
Shield
