NRX-5
-
Display Feature Phone
6
• The volume level, steps from 1 to 4 and will be showed on the LCD
when adjusting.
•
Volume 1 is the lowest level
•
Volume 4 is the highest level
2.2.2 Speakerphone mode:
• During the call, pressing the volume buttons once will decrease or increase
the volume level respectively.
•
There are 8 levels for handsfree speaker.
•
The volume level, steps from 1 to 8, will be showed on the LCD when
adjusting.
•
Volume 1 is the lowest level
•
Volume 8 is the highest level
2.3 Telephone Ringer
The ringer volume and pitch can be adjusted via the two slide switches on the
right side of the NRX-5
The ringer volume can be set to Off, Low or High levels depending on the
position of the switch. There is an LED ring indicator inside the red lens. This
indicator is independent of the ringer volume switch position.
While the phone is ringing, you can adjust the ringer tone of your telephone
by moving the ringer pitch switch.
2.4 Direct Memory Buttons
5 one-touch speed dial numbers and 5 two-touch speed dial numbers can be
programmed into the memory of your phone.
Each memory location can store a maximum 16 digits phone number and a
maximum 16 letters for name.
1. Press the
SELECT
button
2. Enter the phone number using the keypad
3. Press the
SELECT
button
4. Enter the memory name using the keypad
i.e To enter 'A' press the 2 button once, to enter 'B' press the 2 button twice
etc.
5. Press then memory button (Use the
SHIFT
button to access the second bank
of memories).
9021NRX5.qxd 8/12/2003 2:04 PM Page 6
