6. If the engine is cold, move the choke lever
q
to the left until it stops.
TIP
The choke is fully on when the lever is completely to the left. The choke is off
when the lever is completely to the right. The choke can be adjusted gradually,
depending on how much choke is needed for starting.
7. Place the engine stop switch in the ON position, then turn the main key
switch on.
8. Do not press the throttle while starting the engine. Squeeze the left brake
lever.
TIP
The starter will not engage unless the rear brake is applied. Always squeeze
and hold the left brake lever before attempting to start the engine.
9. Press the start button.
10. Activate the starter for a maximum of five seconds, releasing the button
when the engine starts.
NOTICE
Operating the vehicle immediately after starting could cause engine damage.
Allow the engine to warm up for several minutes before operating the vehicle.
11. If the engine does not start, release the start button, wait five seconds, then
attempt to start again. Repeat this procedure until the engine starts.
39
OPERATION
Summary of Contents for Phoenix 200
