6. Install a new sealing washer on the drain plug. The sealing surfaces on the
drain plug and crankcase should be clean and free of burrs, nicks or
scratches.
7. Reinstall the drain plug. Torque to specification.
8. Place towels under the oil filter. Using an oil filter wrench, turn the filter
counter- clockwise to remove it.
9. Using a clean, dry cloth, clean the filter sealing surface on the crankcase.
10. Lubricate the gasket on the new filter with a film of engine oil. Check to make
sure the gasket is in good condition.
11. Install the new filter and turn by hand until the filter gasket contacts the
sealing surface, then turn and additional 3/4 turn.
12. Remove the oil fill plug and add the recommended oil. Do not overfill.
13. Reinstall the fill plug.
14. Start the engine and let it idle for 1–2 minutes.
15. Stop the engine and inspect for leaks.
16. Check the oil level and add oil as necessary to maintain the level at the
center of the sight glass.
17. Discard used oil and filter properly.
FUEL FILTER
This vehicle is equipped with an in-line fuel filter. This filter should be replaced
by your dealer or other qualified person at the intervals recommended in the
Periodic Maintenance Chart sections.
56
MAINTENANCE
Summary of Contents for Phoenix 200
