95
TROUBLESHOOTING
Drive Belt Wear/Burn
Possible Cause
Solution
Driving at low RPM or
ground speed
Drive at a higher speed.
Insufficient warm-up at
low ambient tempera-
tures
Warm the engine at least 5 minutes. With the transmission
in neutral, apply small amount of throttle in short bursts, 5
to 7 times. The belt will become more flexible and pre-
vent belt burning.
Slow/easy clutch engage-
ment
Use the throttle quickly and effectively.
Belt slippage from water
or snow ingestion into the
CVT system
Dry out the CVT (see page 66).
Prevent water from enter-
ing the CVT inlet and outlet ducts (see page 86).
Inspect
clutch seals for damage if repeated leaking occurs.
Clutch malfunction
See your POLARIS dealer.
Poor engine performance
Check for fouled plugs or foreign material in gas tank or
fuel lines. See your dealer.
Wrong or missing belt
Install the recommended belt.
Improper break-in
Always break in a new belt and/or clutch. See page 36.
Summary of Contents for Ranger RZR 170 2013
Page 1: ...2013 Owner s Manual for Maintenance and Safety FOUR STROKE ...
Page 4: ...1 Visit us at www polarisindustries com ...
Page 109: ...106 MAINTENANCE LOG DATE MILES KM OR HOURS TECHNICIAN SERVICE PERFORMED COMMENTS ...
Page 110: ...107 MAINTENANCE LOG DATE MILES KM OR HOURS TECHNICIAN SERVICE PERFORMED COMMENTS ...