STARTING THE ENGINE
1. Position the vehicle on a level surface outdoors or in a well-ventilated area.
2. Sit in the driver's seat and fasten the seat belt. Always make sure all cab
doors are closed and latched when riding in this vehicle.
3. Place the transmission in PARK or NEUTRAL.
4. Engage the park brake.
5. Apply the brakes. Do not press the throttle pedal while starting the engine.
6. Turn the ignition key to the START position. Engage the starter for a
maximum of five seconds. Release the key when the engine starts. Turn the
key to either LIGHTS ON or POSITION LIGHTS ON.
q
OFF
w
LIGHTS ON
e
POSITION LIGHTS ON
r
START
7. If the engine does not start within five seconds, return the ignition switch to
the OFF position and wait five seconds. Repeat steps 6 and 7 until the
engine starts.
8. Vary the engine RPM slightly with the throttle to aid in warm up until the
engine idles smoothly.
NOTICE
Operating the vehicle immediately after starting could cause engine damage.
Allow the engine to warm up for several minutes before operating the vehicle.
STOPPING THE ENGINE
WARNING
A rolling vehicle can cause serious injury. Always place the transmission in
PARK and engage the park brake (if equipped) when stopping the engine.
1. Release the throttle pedal completely and brake to a complete stop.
2. Place the transmission in PARK.
84
Downloaded from
Summary of Contents for RZR S 1000 2020
