46
♦
The wiring and installa=on of this unit requires special technical skill and experience. If you do
not feel confident installing this product or do not have the level of skill necessary, please
contact Polaris on 1300 555 514 so we can refer to a recommended installer.
Unfortunately we do not have the colour codes of every vehicle. To find the correct wires to
tap into, our installers use the following items:
-‐
Test lamp (to find power).
-‐
Mul=meter (to find steering wheel control wires).
-‐
9 volt battery (to find the speaker wires).
This unit is designed to be used in a vehicle with a 12 volt battery and a nega=ve grounding.
Before installing this unit to a recrea=onal vehicle, bus, or truck, make sure the battery
voltage is appropriate for this unit to be used. If installing into a 24Volt vehicle , you will need
a 10 amp converter which can be purchased through automotive electronic shops such as
Jaycar electronics.
To avoid short circuit in the electrical system, ensure that the nega=ve battery cable is
disconnected before installa=on.
To avoid possibility of shor=ng out the electrical circuit in the unit, never connect the battery
wire directly to the vehicle battery.
Always secure all wirings with cable clamps or adhesive tape to prevent short circuit.
Please make sure all wiring connec=ons and speaker wires are well insulated.
When pulling the dash apart, please use quality trim tools to avoid damaging your dash.
Please do NOT cut any plugs off of any Polaris cameras. Doing so will void your warranty! If
you need to blend other brand cameras into our system, please call Polaris on 1300 555 514
so we can refer you to a recommended dealer who has the skill and experience in performing
this type of work.
If you want the reverse camera to trigger when reverse gear is engaged, you will need to find
reverse power. Once you have found reverse power, connect the reversing wire (tagged as
reverse-‐in) to it.
Some vehicles will require extra parts such as:
-‐
Fascia's to make the double din chassis fit nice and neatly.
-‐
CAN bus modules to retain steering wheel controls or other original features of the car.
-‐
modules to retain a factory amp.
Holden vehicles with Mylink will require a special CAN bus module.
Most European vehicles will require a CAN bus module to retain steering wheel controls.
If there is something you are not 100% sure about when installing this unit, please give our
experienced technicians a call on 1300 555 514.
♦
♦
♦
♦
♦
♦
♦
♦
♦
♦
♦
♦
♦
Installa/on Notes