82
MAINTENANCE AND LUBRICATION
Brakes
Front and Rear Brake Inspection
Check brake system for fluid leaks.
Check brake for excessive travel or
spongy feel.
Check friction pads for wear, damage and
looseness.
Inspect the brake disc spline and pad wear
surface for excessive wear.
Change pads when worn to 3/64
″
(.1 cm),
about the thickness of a dime.
Brake Light Inspection
When the brake pedal is depressed, the console brake light comes on.
Check the brake light before each ride.
1. Turn the ignition switch to the ON position.
2. Depress the brake pedal. The brake light should come on after
about 10mm (0.4 in.) of pedal travel. If the light doesn’t come on,
check the bulb.
3/64
″
(.1 cm)
If the brake pedal has a “spongy” feeling when applied, there
may be air in the brake lines, or the brake may be defective. Do
not operate the vehicle under these conditions. Have the brake
system serviced by an authorized Polaris dealer immediately.
WARNING
Headlight and taillight lenses may become dirty. Wash frequently
to maintain lighting quality. Poor lighting while operating can result
in severe injury or death.
WARNING
CAUTION
Do not service while lights are hot. Serious burns may result.
Summary of Contents for UTV Series 10 2x4
