1
Open the 4x5 carrier as described previously.
2
Locate the appropriate adapter for your image. One is
designed for 2
1
/
4
x 2
3
/
4
in. images, and one is for 2
1
/
4
x
2
1
/
4
in. square images.
Note:
The frame of film must be cut
from the film strip in order to be scanned.
3
Orient the adapter so that the words
THIS SIDE UP
(on the
adapter) face up, and the notches are at the left edge (picture
9). Place the unmounted film over the opening, within the
raised ridges of the adapter. Position the film so the image is
right-reading and right-side up. Secure the film with the two
magnets provided, on the top and bottom edges. Be sure the
magnets are also within the raised ridges (picture 10).
4
Place the adapter in the 4x5 carrier, sliding the notches into
the pins on the left edge. The film and magnets should be face
up, as shown (picture 11).
5
Close the carrier. Squeeze the carrier at the bottom edge and
turn the knob to lock it (picture 12).
2-12
11
12
9
10
The 120 film adapters
(for 2 1/4 x 2 1/4 and
2 1/4 x 2 3/4 in. film)
Summary of Contents for SprintScan 45
Page 1: ......
