1
Open the 4x5 carrier as described previously.
2
Locate the single-35mm adapter.
Note:
You can use a nega-
tive, or a mounted or unmounted slide.
3
Orient the adapter so the metal tabs face up, and the notches
are at the left edge. Slide the film into the channel, under the
two metal tabs. Position the film so the image is right-reading
and right-side up (picture 13).
4
If the film is unmounted or the mount is thin, use the slide
spacer provided. Position the slide spacer underneath the slide
(picture 14). The film should fit snugly into the adapter. (The
spacer also ensures that the image will be at the correct dis-
tance from the scanning mechanism.)
5
Place the adapter in the 4x5 carrier, sliding the notches into
the pins on the left edge. The slide and tabs should be facing
up (picture 15).
6
Close the carrier. Squeeze the carrier at the bottom edge and
turn the knob to lock it (picture 16).
Setup and use
2-13
15
16
13
14
The single-35mm
carrier
Summary of Contents for SprintScan 45
Page 1: ......
