6
Connecting the television to power
Insert the power plug into a 120V AC electrical outlet. Unplug the power cord when the television will not be
used for a long period of time.
Turning the television on and off
Turn on the power by using the POWER button on the television or on the remote control.
Using standby mode
If the television is in a non-signal state (is not receiving a television signal) for 15 minutes, the television will
enter standby mode. To turn the television back on, press the POWER button on the television or remote
control.
Changing channels
Change channels by using the
CHAN
/
button on the television or on the remote control. When AN-
TENNA is set to AIR, access the channel by pressing two digits on the remote control. When ANTENNA is
set as CABLE, use three digits on the remote control to select the channel. To select channels above 100,
press and hold the “1” number for two seconds. The OSD shows 1--, then input the other two digits.
Turning the volume up or down
Adjust the sound by using the VOL
/
button on the television or on the remote control.
Basic Operation
