background image

NOTE:

  After step 1, steps 2, 3, and 4 must be done within 30 seconds of 

each other to protect the integrity of the READY MODE starting 
sequence. 

 

MULTI-CAR OPERATION 

The PS-2765 systems feature multi-car operation. This allows the owner of 
two Polarstart systems in two of his/her vehicles to control both systems with 
one transmitter. (Both vehicles must be equipped with a PS-2765) The remote 
transmitter of the primary vehicle can control the starter disable system, the 
door locks and the remote car starter and trunk operation of the second vehicle. 
The remote transmitter of the second vehicle can also operate the primary 
vehicle                    

Second car control: 

Pressing the two following buttons simultaneously controls LOCK: 

Pressing the two following buttons simultaneously control UNLOCK: 

Pressing the following two buttons simultaneously controls remote start/stop 

 

 

 

EXITING READY MODE 

Once a vehicle has successfully been put into READY MODE, any of the 
following events will cause it to exit READY MODE: 
1.  Opening a door * 
2. Pressing 

brakes 

3.  Disengaging Parking brake 
4. Opening 

hood 

5.  Turning off valet switch 

*  NOTE:

  Opening a door while engine is running by remote starter will not 

cause vehicle to shut off, but it will cause it to exit READY MODE.  
Vehicle must again be set into READY MODE in order to start again by 
remote starter. 

 

REMOTE DOOR LOCKS 

If your system was installed with remote door locks, you will have the 
convenience of remote keyless entry. To UNLOCK you doors, press and hold 
Unlock Button 1 for about 1 sec. Once the doors have unlocked the Parking 
lights will flash twice to confirm that the doors are unlocked. (

Also disarming 

your starter kill.)

 

 To LOCK your doors, press Lock Button on your remote. When the doors 
have locked, the Parking lights will flash once. 

(Arming the starter kill.)

 

 

 
 

REMOTE TRUNK RELEASE OR GARAGE DOOR CONTROL 

The Polarstart has the ability to control the trunk release or an external garage door 
opener system. (Option). If your Polarstart was installed with the power trunk 
release option, you can pop your trunk with LOCK  & START Button of the remote 
transmitter. If your Polarstart was installed with the garage door option, the garage 
door can be opened by simply pressing on LOCK & START Button when in front 
of the garage door. 
 

STARTER KILL OPTION 

If your Polarstart was installed with the starter kill option, you will not be able to 
start your vehicle with the keys unless the system has been disarmed first. This 
option works with the door lock sequence. If you did not get the door locks 
installed, ignore the reference to the door locks operation below. 
   To disarm the starter kill system, press and hold Unlock Button to unlock the 
doors. When the system has been disarmed, you will get two quick flashes through 
the Parking lights. 

NOTE

: Locking the doors will rearm the starter kill unit. Once 

the system has been disarmed, you will have approximately 45 seconds to insert the 
key in the ignition, turn it to the ON position and start the engine. 

Once the engine 

has been turned off, the system will rearm in 45 sec. 
 
SAFETY FEATURES 

Polarstart is equipped with a Valet switch (ON / OFF) make sure that all users of the 
vehicle know the location of the switch. 
You should turn the switch OFF when: 

• 

Servicing Vehicle 

• 

Parking indoors (Garage) 

• 

If there are problems with the remote starter. 

When the switch is turned ON, the Parking lights will flash twice to confirm that the 
car-starter is in operation.  Polarstart is equipped with a pin switch in the engine 
compartment.  When the hood is raised, the PS-2765 is disabled. A faulty pin switch 
can disable the remote starter. Make sure the pin switch is in good working 
condition for reliable starts. 
 

COLD WETHEAR STARTS 

The Polarstart has a feature that allows your vehicle to start every two hours for 4 
minutes. This helps keep the engine warm during cold weather and makes starting 
easier. To place the Polarstart into cold weather mode, press and hold START 
Button for about 5 sec. 
 

SECURE LOCK 

Secure lock is for cars that arm and disarm off the lock and unlock wires.    
(I.e…VW’s) When secure lock is activated it will unlock the doors prior to remote 
start the car. Once the car is started it will relock the doors. (Usually not rearming 
the factory security). After remote shutdown or run time out it will relock the doors 
again. (Rearming factory security)   

 

 

 

 

3

Reviews: