Polarstart PS-3185SH, Installation Manual

PS-3185SH 

Installation Guide  

P. 15

OPTION 2* 

Turbo Mode 

DISABLED

OPTION 3

Turbo Mode

ENABLED

FUNCTION 4 – Engine type and Cold Weather Mode 

OPTION 1 

Diesel Mode with 20-minute Run Time in Cold Weather Mode 

OPTION 2* 

Gas Mode with 4-minute Run Time in Cold Weather Mode 

OPTION 3 

Diesel Mode with 9-minute Run Time in Cold Weather Mode 

FUNCTION 5 – Ignition Valet 

OPTION 1

Ignition Valet 

DISABLED

OPTION 2* 

Ignition Valet 

ENABLED

OPTION 3 

Ignition Valet 

ENABLED

MODE 3

* INDICATES DEFAULT SETTING 

FUNCTION 1 – Home Valet 

TM

OPTION 1 

Home Valet 

ENABLED

OPTION 2* 

Home Valet 

DISABLED

OPTION 3 

Home Valet 

DISABLED

FUNCTION 2 – 

AUX 3

 / Zone 3 Programming 

OPTION 1 

1-sec. output when 

TRUNK

 button is pressed for 3 sec. with Ignition 

OFF

or under remote run 

OPTION 2* 

Constant output while the 

TRUNK

 button is pressed  

OPTION 3 

Output with Disarm and Rearm pulses 

FUNCTION 3 – 

AUX 2

 Programming 

OPTION 1 

Constant output while the 

LOCK

 and 

UNLOCK

 buttons are pressed. 

In Safe Start Mode: activate 

AUX 2

 by pressing the 

START

 button. 

OPTION 2* 

Toggle 

ON/OFF

 (with 30-second timeout) 

OPTION 2 

Horn confirmation when lock. 

OPTION 4 

Priority Door Access 

FUNCTION 5 – External Trigger 

OPTION 1

Zone 3 disarm/rearm (Trunk Pin: a disarm pulse is sent before the Trunk  

opens, the vehicle rearms 4 seconds after the Trunk is closed). 

OPTION 2* 

Engine Start/Stop 

OPTION 3 

Key Sense 

Tach Programming 

About Tach Programming 

If you press the 

START

 button before carrying out a Tach Programming procedure, the Remote Car 

Starter will make no attempt to start the Engine and the Parking Lights will give 5 flashes.  
If order to carry out Tach Programming, you may simply follow the Automatic Tach Programming 
procedure.  
The Remote Car Starter stores Tach settings regardless of the procedure used at the time of Tach 
programming. All Tach settings are cleared when the Remote Car Starter is reset. A new Tach 
Programming procedure has to be carried out 

only

 if the Remote Car Starter is reset. 

Multi-speed Tach Programming 

Tach signals may vary from vehicle to vehicle. The

Remote Car Starter is designed to read a wide 

range of Tach signals produced by recent Ignition systems. There is no necessary manual 
adjustment. Nevertheless, a Tach-programming procedure 

must 

be carried out 

every time a new 

Remote Car Starter Unit is installed

. This is because the Tach signals of certain Ignition systems