8
HARNESS DESCRIPTION (11 PIN)
8
Brown (Lock)
18 AWG
On cars with
Negative Trigger
door lock systems, this
wire can be attached directly to the wire that
unlocks
the
doors when a ground is applied.
9
Green
(Unlock)
18 AWG
Pin 85 of a relay added for this feature. Sends a
GROUND signal.
10
Blue (Trunk)
18 AWG
Pin 86 of starter kill Relay (see diagram).
11
White
(Starter Kill)
18 AWG
Connect to the car circuit, usually the dome lights circuit,
that gives a GROUND when a door is open
.
12
White/Black
(- Door sense)
18 AWG
Connect to the car circuit, usually the dome lights circuit,
that gives +12V when a door is opened
.
13
Orange/Black
(+ Door sense)
18 AWG
Connect to OEM Glow-Plug light wire that tests +12
volts with the lights ON. Some vehicles (FORD,
DODGE) are equipped with negative glow plug light
signals, relay must be used to invert signal.
14
Yellow
(+ Glow-Plug light
input)
18 AWG
This wire will OUTPUT a negative signal for 1 sec. upon
reception of a START command from the remote
transmitter.
This wire will also output a 1 sec. ground when the doors
are UNLOCKED by remote.
15
White/Green (-)
DISARM
18 AWG
+12V siren output. Connect to the positive side of the
siren.
16
Red (Siren)
18 AWG
This wire will activate the remote starter when a 1 sec.
ground pulse is sent to this wire from a pager unit, timer,
or external receiver. (Must be programmed ON – Mode
2, Function 4, Option 2)
17
Blue/Black (-)
External Trigger
input
18 AWG
This wire will OUTPUT a negative signal 1 sec. after a
remote start, and will also give a signal 3 sec. after
system controlled engine shut-down.
Wire will also output a 1sec. pulse when the doors are
LOCKED by remote.
18
White/Brown (-)
RE-ARM output
18 AWG
HARNESS DESCRIPTION (5-PIN)
PIN #
COLOR
SIZE
CONNECT TO
A
RED (Battery)
14 AWG
+12 volt BATTERY input.
B
YELLOW
(IGNITION)
14 AWG
Wire at key switch which has +12V when key is in the
Ignition (ON) and
crank (START) position.
C
VIOLET
(STARTER)
14 AWG
Wire that has +12V
ONLY
WHEN THE KEY SWITCH IS IN THE
CRANK
POSITION. (Attach a wire coming from pin 87A of the Starter
kill relay if this feature is used).
D
ORANGE
(Accessories)
14 AWG
Wire at key switch that has +12V when the Ignition key is in
Ignition
and/or Accessories position only (NOT CRANK POSITION).
E
RED (Battery)
14 AWG
+12 volt BATTERY input.
•
NOTE:
Constant 12 volts wires must be connected to heaviest gauge 12 volt wires at Ignition switch.
When there are two constant 12 volt wires at Ignition switch wires A and E must be separated (each to
their own 12 volts source). When there is only one 12 volt source at Ignition switch then and only then
can they be connected together.
Summary of Contents for PS-5500
Page 9: ...9 ...
