P. 10
User Guide
Press the
TRUNK
button to lock the doors; the engine will shut down after
60 seconds of Turbo Mode.
Valet Mode with the Valet Switch
When your vehicle is in Valet Mode, the remote starter functionalities are disabled. If the vehicle
needs to be serviced, or if you park it indoors, the Valet Mode will prevent the engine from being
remote-started accidentally.
To put the system i n t o Valet Mode:
1.
Turn the ignition key to the
IGNITION ON (RUN)
position.
2.
Within 3 sec., press the valet button. The parking lights will flash 3X and the L.E.D.
will come
ON
solid.
To take the system o u t o f Valet Mode:
1.
Turn the ignition key to the
IGNITION ON (RUN)
position.
2.
Within 3 sec., press and release the valet button. The parking lights will flash 2X and
the L.E.D. will turn itself
OFF
.
Note
: Once Valet Mode is activated, the remote starter and alarm functions will be disabled.
Ignition Valet
This feature will allow you to remotely put your system into Valet Mode by using the ignition key
instead of the Valet button as above. Ignition Valet can be used without a Valet button installed.
To put the system i n t o Valet Mode:
•
Insert the ignition key into the ignition switch. Within 10 sec.,
turn the key 5 times successively into the
IGNITION ON / RUN
and
OFF
positions.
•
The parking lights will flash three times to indicate that the vehicle is now in Valet Mode.
The L.E.D. will come
ON
solid.
To take the system o u t o f Valet Mode:
•
Insert the ignition key into the ignition switch. Within 10 sec., turn the key 5 times
successively into the
IGNITION ON / RUN
and
OFF
positions.
•
The parking lights will flash twice to indicate that the vehicle is out of the valet mode and
the L.E.D. will turn itself
OFF
.
Note
: With the Remote Valet activated, the remote starter and alarm functions will be disabled.
Start Attempts Indicator (Valet Mode)
This reveals start attempts made while the vehicle was in
Valet Mode
. The parking lights will:
•
Come
ON
, go
OUT
; then
•
Flash
twice
.
“Home Valet
TM
” Mode
If configured at installation, this feature will remotely set the vehicle to a no-remote-start mode: if
the vehicle is parked indoors there is no danger of it starting accidentally by remote control.
Note:
Once the Home Valet Mode is activated, the vehicle will not start by remote.
To take the system i n t o Home Valet Mode:
•
Press the
LOCK
or
UNLOCK
button.
•
Within 5 seconds, press the Lock and
START/STOP
button simultaneously.
The transmitter will beep once and the Home Valet icon will start flashing.
The icon will flash until the vehicle exits Home Valet Mode.
To take the system o u t o f Home Valet Mode:
•
Turn the ignition key to the
IGNITION ON (RUN)
position.
