16.Barrier alignment - IR section
25
POLITEC | INSTALLATION MANUAL - VER.3.1
Since the columns are already fixed for the alignment of the Microwave, orient the optics of the
transmitters and the optics of the IR receivers, one towards the other, adjusting the lens holder
horizontally manually, after having loosened the locking screw on the joint and vertically through the
front screw located to the left of the lens.
Vertical orientation
Horizontal orientation
JOINT LOCKING
SCREW
N.B.:Tighten the joint locking screw after making the adjustment
16.1 Calibration using SMA system
It is possible to improve the calibration by using the supplied filter.
It is sufficient to apply the filter only on the TX, there is no need to repeat the operation also on
the RX.
MANA DT SMA
1.
Fold
the
device
following the pre-set
folds
2.
Position the filter in
front of the TX optic
inserting
the
two
hooks on the pins of
the optic fork.The
filter is designed to
refine the search for
the alignment signal
under
critical
conditions.
