4
5
Polk Customer Service 800-377-7655 (Outside USA & Canada: 410-358-3600)
Customer Service Hours of Operation: Monday-Friday, 9am-5:30pm est polkcs@polkaudio.com
19. Replacement Parts. When replacement parts are
required, be sure the service technician has used
replacement parts specified by the manufacturer
or that the parts have the same characteristics
as the original part. Unauthorized substitutions
may result in fire, electric shock or other hazards.
CAUTION:
Danger of EXPLOSION if battery
is incorrectly replaced. Replace only with the
same or equivalent type. (CR2025)
WARNING:
Do not expose batteries or battery pack
to excessive heat such as sunshine, fire or the like.
20. Safety Check. Upon completion of any service or repairs
to this product, ask the service technician to perform
safety checks to determine that the products are in
proper operating condition.
21. Carts and Stands. The appliances should be
used only with a cart or stand that is recom-
mended by the manufacturer. An appliance
and cart combination should be moved
with care. Quick stops, excessive force, and uneven
surfaces may cause the appliance and cart combination
to overturn. Use caution when moving the cart/apparatus
combination to avoid injury from tip-over.
22. This product is not intended for use outdoors.
The
CAUTION
marks shown here are located on the back
of your SurroundBar
®
Speaker System
CAUTION:
To prevent electric shock, match wide blade
of plug to wide slot, insert fully.
CAUTION:
No naked flame sources, such as candles,
should be placed on the apparatus.
Radiation Exposure Statement
This device complies with FCC radiation exposure limits set
forth for an uncontrolled environment and it also complies
with Part 15 of the FCC RF Rules.
This equipment should be installed and operated
with a minimum distance of 20 centimeters between
the radiator and your body.
Operation
This equipment complies with Part 15 of the FCC Rules
and Industry Canada RSS-210. Operation is subject
to the following two conditions:
1) This device may not cause interference, and
2) This device must accept any interference, including
interference that may cause undesired operation
of the device.
Class B Emissions Limits
This Class B digital apparatus meets all requirements
of the Canadian Interference—Causing Equipment
Regulations.
The device meets the exemption from the routine evaluation
limits in section 2.5 of RSS 102 and compliance with RSS-
102 RF exposure, users can obtain Canadian information
on RF exposure and compliance.
Product Disposal
Certain international, national and/or local laws and/
or regulations may apply regarding the disposal of
this product. For further detailed information, please
contact the retailer where you purchased this prod-
uct or the Polk Importer/Distributor in your country. A listing
of Polk Importer/ Distributors can be found on the Polk
website: www.polkaudio.com or by contacting Polk at:
5601 Metro Drive, Baltimore, Maryland 21215, USA.
Phone: 1-410-358-3600; in California: 1-800-377-7655.
NOTE:
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy, and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following mea-
sures: Reorient or relocate the receiving antenna. Increase
the separation between the equipment and receiver. Connect
the equipment into an outlet on a circuit different from that
to which the receiver is connected. Consult the dealer or an
experienced radio/TV technician for help.
• The antenna(s) used for this transmitter must be installed
to provide a separation distance of at least 20 cm from
all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter.
• Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment.
Inside Your SurroundBar
2000 IHT Carton:
Important Note:
If anything is missing or dam-
aged, or if your Polk SurroundBar 2000 IHT fails
to operate, please notify your dealer immediately.
We recommend keeping your original carton
and packing materials in case you need to
ship the unit in the future.
Specifications
Dimensions
3 3/4" H x 31" W x 2 1/2" D
(9.53 cm x 78.74 cm x 6.35 cm)
Weight
4 lbs 14 oz (1.88 kg)
Power Requirements
20 V, 2.7 A
Model
SurroundBar 2000
Instant Home Theater
Remote Battery
CR2025
Remote Control
6' Digital
(Optical) Cable
Remote Control
(Battery Included)
SurroundBar
20V Power
Supply
Owner’s
Manual
Quick Start
Guide
Online
Registration
Card
Source 1
VOL
BASS
SOURCE
Power
Mute
Source 2
Bass Volume
Volume
