Polk Audio XRt12 CI Guide
Page 3
1/19/05
Revision 3.0
to locate the antenna where there is a strong XM signal, please see the
section below on extension Cables.
B.
Extension Cable:
Your High-Gain Home Antenna comes with 20-feet of cable. If that is not
sufficient to locate the antenna where there is a strong XM signal, purchase a
50-foot cable extension (Polk Audio recommends the Terk XM-EXT50) from
Polk Audio (
http://shop.polkaudio.com
) or your local retailer. Up to two
extensions can be used together for a total of 120-feet of cable.
XM-EXT50
The Terk XM-EXT50 cable is 50-feet long, weather resistant, and has a built
in signal amplifier to match the input gain with the XRt12 XM Reference
Tuner.
C.
Prewire installation:
Prewire installation can be accomplished by using the 50-foot extension cable
(Terk XM-EXT50) to route from the XRt12 Tuner location to the desired
antenna location. The Antenna that comes with your XRt12 tuner has 20-feet
of cable and up to two extension cables can be used for a total antenna cable
length of 120-feet.
For installations that require cables longer than 120-feet, we do not have an
adequate solution at this time. We are working with Terk to develop a
solution in the near future. Please contact us if this is a requirement for your
installation.
D.
Antenna Splitters:
With the use of the Terk XM-SP you can connect two XRt12 units to a single
antenna cable.
Terk XM-SP
