Fig #1:
In order to make the assembly of this
Economizer Bench easier while going through
the assembly process the board positions are
numbered and will be referenced in later steps.
Step #1:
Stand (1) One bench end (Part B) upright and place (1) One bench board
(Part A) on position 1 being sure to align the pre-drilled holes to the pilot
holes in the bench end. After the holes are properly aligned, fasten with
(1) One #12 x 3" Flat Head Phillips Screw in the top pre-drilled hole.
Note: Do not tighten screw completely. This will be done in a later step.
FS-EM6BA-CAP-03
#12 x 3" Flat Head
Phillips Screw
1
2
3
4 5 6
7
Summary of Contents for Economizer FP-EM6BA-CU-03
Page 9: ...FS EM6BA CAP 03 ...
