Step #2:
Stand the other two bench end (Part B) upright and place the bench board
(Part A) already attached to the first bench end, on position 1 being sure to
align the pre-drilled holes to the pilot holes in the bench end. After the
holes are properly aligned, fasten with (1) One #12 x 3" Flat Head Phillips
Screw in the top pre-drilled hole.
Note: Do not tighten screws completely. This will be done in a later step.
FS-EM4BA-CAP-03
#12 x 3" Flat Head
Phillips Screw
Summary of Contents for Economizer FP-EM6BA-CU-03
Page 9: ...FS EM6BA CAP 03 ...
