POLTI SANI SYSTEM CHECK Instructions Manual Download

Page: 23 / 32

CORRECT USE OF THE

PRODUCT

This equipment is for professional use, in ac-
cordance with the descriptions and instructions
contained in this manual. The system delivers
saturated steam at a high temperature com-
bined with the sanitising agent HPMED in or-
der to lower the bacterial, fungous and viral
load on the surfaces to which it is applied. This
makes it possible to reduce the possibility of
cross-infections. Read these instructions care-
fully and keep them for future reference.

Polti S.p.A declines liability for any dam-
age or accident derived from any use of
this appliance which is not in conformity
with the instructions contained in this
manual.

ATTENTION

Directive 2002/96/EC (Waste Electrical and
Electronic Equipment - WEEE):
information for users
This product complies with EU Directive
2002/96/EC.

The crossed-out wastebasket sym-
bol on the appliance means that at
the end of its useful lifespan, the
product must be disposed of sepa-

rately from ordinary household wastes.
The user is responsible for delivering the ap-
pliance to an appropriate collection facility at
the end of its useful lifespan.
Appropriate separate collection to permit re-
cycling, treatment and environmentally com-
patible disposal helps to prevent negative im-
pact on the environment and human health
and promotes recycling of the materials mak-
ing up the product. For more information on
available collection facilities, contact your lo-
cal waste collection service.

HPMED

The sanitising agent

Its characteristics make it the ideal comple-
ment to SANI SYSTEM POLTI for sanitising
any surface at risk of contamination by patho-
genic organisms, and in particular bacteria.
Thus, the dry steam of SANI SYSTEM POLTI

becomes the ideal means for carrying the
temperature and the HPMED sanitising
agent. The mixture of steam and HPMed suc-
ceeds, so, to reach even the most inaccessi-
ble corners. While it sanitises, it also elimi-
nates smells.

Instructions for use :

Fit the disposable bottle into the delivery de-
vice following the instructions in paragraph
“DISPOSABLE BOTTLE OF HPMED”.
Switch on the SANI SYSTEM POLTI ma-
chine following the manufacturer’s instruc-
tions. Once the system is ready, distribute the
steam and HPMED sanitising agent. Mixed
with the steam, the product will dry within 30
seconds to one minute, depending on the en-
vironmental conditions.

Warnings :

Keep out of the reach of children. Do not in-
gest. In case of contact with eyes, rinse with
plenty of water and seek medical advice.
A safety data sheet is available for profes-
sional users.
For professional use only.
HPMED is a cleaning sanitisin product for
hard surfaces. Contains <5% non-ionic sur-
factant. (EEC Reg. 648/2004).

PREPARING FOR USE

• Unscrew the cap (

) from the tank and fill

the tank with about 4.5l of normal tap water.
Disconnecting of the device from the power
mains before filling is recommended.

• Fit the carrier grip as shown in Fig.1, tighte-

ning the two screws on the rear of the grip
to secure it in place.

• Plug the power cable (

) into the panel-

type socket on the rear of the device. Plug
the connector on the other end of the power
cord into a suitable socket with an earth
connection.

• Fit the disposable bottle into the delivery de-

vice following the instructions in paragraph
“DISPOSABLE BOTTLE OF HPMED”.

SANI SYSTEM CHECK